Use the water supply pipe to install in the water outlet pipe position, turn on the water supply to let cold water in to flush the tank, then dirty water will come out from the sediment discharge valve.
After rinsing for about 1-2 minutes, when the dirt inside the tank is gone, remove the water supply pipe from the water inlet pipe and reinstall the water pipes as before.
With the Magnesium rod, you should clean it before reinstalling it in the tank. If the Magnesium rod is more than 60% corroded, it needs to be replaced immediately. If not replaced, the Magnesium bar will combine with the metals in the tank, causing leakage, corroding the tank shell and affecting the user.
With just a few simple steps as above, the dirt in the water heater will be removed. According to experts, to prevent too much dirt from accumulating inside the tank, it is best to clean the tank this way about once every 6 months.
How to use a water heater safely and save electricity
Choose the capacity and capacity suitable for your needs
When choosing to buy a water heater, choosing the capacity and capacity of the tank to suit your needs is very important. If you choose a water heater with a larger capacity, it will consume more electricity.
Choose reputable, quality brands
In addition to choosing the capacity of the water heater to suit your family’s needs, you should buy a water heater from a reputable brand. Because quality products are applied with many modern and advanced technologies, they will save electricity and ensure safety when used.
Do not let the water heater operate 24/24 hours
During use, many users have the habit of turning on the water heater 24/24 hours to save time. Turning on the water heater all day will waste electricity, damage the machine and is unsafe for users. Therefore, only turn on the machine about 10 – 15 minutes before use.
